-
The Capacitor of Energy Storage Spot Projection Welding Machine
The device that stores charge in the energy storage spot welder is a capacitor. When the charge is accumulated on the capacitor, a voltage will be generated between the two plates. Capacitance describes not the amount of charge stored in the capacitor, but the ability to store charge. How much ch...Read more -
What factors are related to the effect of energy storage spot welding machine?
What factors are related to the effect of energy storage spot welding machine? Let’s take a brief look at: 1. Welding current; 2. Welding time; 3. Electrode pressure; 4. Electrode raw materials. 1. Influence of welding current It can be seen from the formula that the impact of curr...Read more -
Is the welding circuit of medium frequency spot welding machine important?
Is the welding circuit of medium frequency spot welding machine important? The welding circuit is generally composed of the secondary winding of the solder resist transformer, hard conductor, soft conductor (composed of multiple layers of thin pure copper sheets or multiple sets of multi-core cop...Read more -
The Importance of Safety Grating for Medium Frequency Spot Welding Machine
When the medium frequency spot welding machine is working, the welding pressure is hundreds to thousands of kilograms instantaneously. If the operator works frequently and does not pay attention, crushing events will occur. At this time, the safety grating can come out and be installed at the loc...Read more -
What is the use of the water channel distributor of the medium frequency spot welding machine?
The water cooling system is very important for the intermediate frequency spot welder. The temperature of each part of the welding heat during operation is different. Especially the welding part is seriously heated, which requires a large amount of cooling water to cool the weld nugget and electr...Read more -
How to control the welding quality of Capacitor Discharge Spot Welder?
Although Capacitor Discharge Spot Welder are suitable for multi-point welding, there will be big problems if the quality is not up to standard. Since there is no online non-destructive welding quality inspection, it is necessary to strengthen the management of quality assurance. Pr...Read more -
What are the environmental requirements of medium frequency spot welding machine?
The use of the medium frequency spot welding machine environment is relatively strict, because the equipment structure is relatively complex, so in the water cooling, power supply, working environment requirements are high, before the power must carefully check the connection cable, ground wire, ...Read more -
Detail the composition of the medium frequency spot welder
The medium frequency spot welding machine is composed of a frame, welding transformer, electrode and electrode arm, pressure mechanism and cooling water, etc. The welding transformer is a secondary loop with only one circle, the upper and lower electrodes and electrode arm are used to conduct wel...Read more -
What are the cooling water quality requirements for intermediate frequency spot welding machines?
What are the cooling water quality requirements for intermediate frequency spot welding machines? Generally, the content of sulfate ions, silicate ions and phosphate ions in groundwater and surface water is low, while the content of bicarbonate ions is high. Therefore, the scale produced in the c...Read more -
How to solve the problem of virtual welding in multi-spot welding of medium frequency spot welding machine?
After the multi-spot welding of the medium frequency spot welding machine is debugged, the phenomenon of missing welds and weak welds generally does not occur. If it does, it should be caused by the failure to adjust the welding parameters, the electrodes not being ground for a long time, water c...Read more -
Is the pressurization system of medium frequency spot welding machine important?
Is the pressurization system of medium frequency spot welding machine important? The pressurization system is not just a cylinder problem. The follow-up performance should be good, the internal friction coefficient should be small, and the guide shaft should be designed together with the cylinder...Read more -
What are the bumps on the workpiece welded by the medium frequency spot welder?
There are two types of bump shapes on the workpiece welded by the medium frequency spot welding machine: spherical and conical. The latter can improve the stiffness of the bumps and prevent premature collapse when the electrode pressure is high; it can also reduce splashing caused by excessive cu...Read more
